PURE TEMPUS-1 Specifications download pdf (Page 17)

Troubleshooting

This section gives some of the most likely solutions to problems you might have with your TEMPUS-1.

I can’t hear the station I have selected on the display

The top line of the display shows the currently selected station. To change station you need to scroll the station list displayed on the bottom line

of the display and confirm your selection by pressing the Tune knob.

I hear a ‘burbling’ sound on some stations

Although DAB is excellent at providing quality audio from very little signal, the quality can suffer if the signal strength is too low. If that happens,

a ‘burbling’ sound can sometimes be heard. To help reduce this, check that your aerial is fully extended and upright. If the problem persists try

moving your TEMPUS-1 or repositioning your aerial using the tuning aid. See page 18 for additional advice on aerials.

Display says ‘No stations available’

If you autotune and you see the above message it means that no stations have been found during the search. Check that your aerial is connected

and fully extended. You will be shown a menu of options. Use the Tune knob to scroll through the following options and push it to select one.

Tuning aid – see Using the Tuning aid on page 18 for details of using the tuning aid to improve reception.

Autotune local – scans all UK frequencies. This should only take a few seconds.

Autotune full – scans the full frequency range in Band III. This may take a minute or more.

My alarm/timer didn’t work

Check that you set the alarm or timer on (If display mode is set to clock you will see a timer or alarm icon on the display). See pages 10 to 12.

Check that the station you are tuned to is available – the clock/alarm/timer relies on the time signal broadcast by the multiplexes.

If you are using synchro-record check that you have set the Digital out to Off/Timer this triggers your recorder. See page 12.

Clock shows the wrong time

This may happen if the multiplex you are tuned to broadcasts an incorrect time signal, try tuning to a station in another multiplex.

None of the buttons seem to work

If the display is on but no buttons seem to work your TEMPUS-1 may be in standby with backlight switched on. If so, you should see a standby

indicator on screen. See page 13 for details. Push standby to switch your unit on.

I can’t see my clock in the dark

Touch the SnoozeHandle to illuminate the display if your unit is in standby.

To set the backlight permanently on, change the display standby mode to on. See page 13.

For the latest troubleshooting information visit the support section on our website at www.pure-digital.com.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23

Comments to this Manuals

No comments

PURE TEMPUS-1 Specifications Page 17

Comments to this Manuals

Related products and manuals for Radios PURE TEMPUS-1