PURE M3700 User Manual download pdf (Page 21)

M3700 user manual

6.2.2 DHCP Mode

1. Connect the unit to a suitable Power source.

2. Connect a traditional phone set to the “FXS” connector located on the rear panel.

3. When the CPU/ACT light is on, pick up the phone to hear the dialing tone.

4. ##0000 ; you should hear three short tones.

5. 011

# ; the digit “0” is used to enable “DHCP” IP mode.

6. 15123

# ; “123” is the web management password.

7. 981

# ; Warm-restarts.

8. Hang up the phone. The system should now restart.

You can also use console to configure IP address.

(For Telnet, From Windows, Start Æ Run Æ Telnet 192.168.0.2 (192.168.0.2 is the default IP of this

machine, change it if the IP is changed.)

SIP-RG>enable

SIP-RG#configure

Enter configuration commands, one per line. End with CNTL/Z

SIP-RG(config)#ip state dhcp

SIP-RG(config)#exit

SIP-RG#restart

This command resets the system. System will restart operation code agent.

Reset system, [Y]es or [N]o? Yes

6.2.3 PPPoE Mode

If your network environment is using PPPoE, you need to prepare the information as specified in

section

5. Information required before Installation.

The following table shows an example.

PPPoE Password 123ab

Web management password 123

There are three ways to configure user name and password of PPPoE

6.2.3.1 1. Use phone set to configure:

You can configure the user name and password by using phone set. The command ‘09’ is used for

username and ‘10’ is for password of PPPoE. Since the user name and password use characters

and digits are accepted by phoneset only, you need a mapping between characters and digits. You

DCC NO. 91710015011

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 91 92

No comments

PURE M3700 User Manual Page 21